Send inquiry
Product parameters:XSK-65T
Technical Descriptions :
1.The bed is made of high strength cast iron, the internal stress relief, the material stability, precision constant, the most suitable for stamping production.
2.The double guide pillar and a central column structure are used to replace the traditional sliding plate structure by adding a special alloy copper sleeve, and the dynamic friction is minimized, and the hot deformation is reduced to a minimum while the thermal deformation is reduced to a minimum.
3.Optional anti side dynamic balancing device to reduce vibration, so that the press has the best accuracy and stability.
4.Manual adjustment mode, with the high voltage display device is too high pressure locking device, easy to adjust the mode operation.
5.High speed punch interface microcomputer control, numerical control, fault monitoring system display operation is convenient .
Standard Configuration:
>Top stop
>Manual slider adjusting device
>Mould-height indicator
>Frequency converter
>Programmable control (PLC)
>Touch screen (pre-set pre-cut, and counter, angle indicator)
>Encoder (electronic) reserved (2 groups)
> Operation box
>Air source connector
>Mould Sticking release device
>Main motor (adjustable speed)
>Hydraulic -mould locking
>Mechanical crank angle indicator
>Forced -circulation Lubrication device
>Tool box
>Operating manual
>Power socket
Optional Configuration:
>Anti-vibration foot
>Feeder
>Decoiler
>Material oil lubricating device
>Bottom dead center detector
>Oil cooler
>Air-blast device
Name | Unit | C-Frame | |||
Capacity | Ton | 65 | |||
Stroke of Slide | mm | 50 | 40 | 30 | 25 |
Stroke per minute | spm | 200-500 | 200-600 | 200-700 | 200-750 |
Die-Height | mm | 200-250 | 205-255 | 210-280 | 212-262 |
Bolster | mm | 900×500×120 | |||
Area of Slide | mm | 540×340 | |||
Slide Adjustment | mm | 50 | |||
Bed Opening | mm | 600×120 | |||
Motor | hp | 15 | |||
Gross Weight | kg | 8500 | |||
Lubrication | Forceful Automation | ||||
Speed Control | Panasonic | ||||
Clutch&Brake | Air&Friction | ||||
Auto Top Stop | Standard | ||||
Vlibration System | Option |
Technical Descriptions :
1.The bed is made of high strength cast iron, the internal stress relief, the material stability, precision constant, the most suitable for stamping production.
2.The double guide pillar and a central column structure are used to replace the traditional sliding plate structure by adding a special alloy copper sleeve, and the dynamic friction is minimized, and the hot deformation is reduced to a minimum while the thermal deformation is reduced to a minimum.
3.Optional anti side dynamic balancing device to reduce vibration, so that the press has the best accuracy and stability.
4.Manual adjustment mode, with the high voltage display device is too high pressure locking device, easy to adjust the mode operation.
5.High speed punch interface microcomputer control, numerical control, fault monitoring system display operation is convenient .
Standard Configuration:
>Top stop
>Manual slider adjusting device
>Mould-height indicator
>Frequency converter
>Programmable control (PLC)
>Touch screen (pre-set pre-cut, and counter, angle indicator)
>Encoder (electronic) reserved (2 groups)
> Operation box
>Air source connector
>Mould Sticking release device
>Main motor (adjustable speed)
>Hydraulic -mould locking
>Mechanical crank angle indicator
>Forced -circulation Lubrication device
>Tool box
>Operating manual
>Power socket
Optional Configuration:
>Anti-vibration foot
>Feeder
>Decoiler
>Material oil lubricating device
>Bottom dead center detector
>Oil cooler
>Air-blast device